InnoMax Adjustable Bed Base - Manual (Page 15)

PowerBASE™ Owners Manual 99300787-i
15
h. When installing a headboard,
footboard, or four-piece surround
(case good), allow for 1.5 inches
(38.1mm) to 2 inches (50.8mm) of
clearance at the head and foot of the
bed and a minimum of ½ inch to ¾
inch on the sides (
FIGurE 24).
i. Firmly tighten the 3 inch carriage
bolts of both headboard bracket
channels.
j. Measure the distance (center-to-
center) between the mounting holes
in the headboard.
k. Measure the center-to-center
distance between the mounting slots
of the headboard bracket flanges
(
FIGurE 25).
l. If bracket flange adjustment is
required to accept the headboard,
remove the
1 inch long hex
head bolts adn
move flanges
side-to-side for
the adjustment
(
FIGurE 25).
Reinstall bolts.
Tighten all
headboard
mounting bolts.
m. Install
headboard.
12. Install mattress on
the adjustable bed
base.
Typical PowerBASE ™
adjustable bed
installation is now
complete. If bed is equipped
with programmable settings
or options, reer to the Hand
control Guide for programming
information.
slide
Bra
Cke
T
asse
MBlies
in O
r
OuT T
O a
CHieve
pOsi
TiO
n
1.5” to 2”
use (2) 1 inCH lOnG HeX Head
BOlTs TO aTTaCH HeadBOard
BraCkeT flanGe TO BraCkeT
CHannel
HeadBOard
BraCkeT
flanGe
fiGure 24: Bed base Type B headboard bracket flange
attachment.
adjusTaBle
Bed Type B
Measure flanGe slOTs
CenTer-TO-CenTer TO CHeCk
HeadBOard HOle lOCaTiOn
reMOve 1 inCH lOnG HeX Head BOlTs and relOCaTe
flanGes TO aCHieve CenTer-TO-CenTer disTanCe
required fOr HeadBOard MOunTinG HOles
fiGure 25: Headboard bracket measurement and adjustment to accept
headboard.
insTallaTiOn
NOTE
Twin size HeadBOard BraCkeT asseMBlies are
sHOwn (fiGures 23 and 24). queen size HeadBOard
BraCkeTs are equipped wiTH anGle BraCes.