InnoMax Adjustable Bed Base - Manual (Page 10)

PowerBASE™ Owners Manual 99300787-i
10
insTallaTiOn
profile-dC Mattress retainer
10. Install Profile-DC mattress retainer at the
foot end of the bed base as follows:
a. locate (1) mattress retainer and
(1) mattress retainer hardware kit
(
FIGurE 7).
MaTTress
reTainer
a
B
C
MaTTress reTainer
Hardware kiT COnTains:
(4) MaTTress reTainer BOlTs - a
(4) flaT wasHers - B
(4) reTaininG Clips - C
fiGure 9: wooden locator pins mark position of the
threaded lugs.
fiGure 10: detail of one side of mattress retainer installed
(shown from the underside of the bed base).
fiGure 7
b.Install (1) flat washer, (1) retaining
clip on (4) mattress retainer bolts
(
FIGurE 8).
c. With the bed base oriented top-side-
up, lay under the foot end of the bed
and locate (4) threaded lug locator
pins (
FIGurE 9).
d. Pull out wooden locator pins to
expose threaded lugs.
e. Align mattress retainer until it makes
contact with the end of the bed base
(
FIGurE 10).
f. Holding the retainer in place, install
the (2) inside mattress retainer bolts
(loosely) into the threaded lug fittings
(
FIGurE 10).
g. Install the (2) outside mattress
retainer bolts ( FIGurE 10).
reTaininG
Clip
flaT wasHer
BOlT
aSSEMBLE (4)
FaSTENErS aS
INDICaTED
fiGure 8
wOOden
lOCaTOr pins
align
retainer
to make
contact
with end
of bed
base.
inside MaTTress
reTainer BOlT
OuTside MaTTress
reTainer BOlT