InnoMax Adjustable Bed Base User Manual

Page 12

PowerBASE™ Owners Manual 99300787-i

failure TO fOllOw HeadBOard
BraCkeT insTallaTiOn insTruCTiOns
May Cause HeadBOard BraCkeT
inTerferenCe wiTH Base fOaM durinG
adjusTaBle Bed OperaTiOn. Base fOaM
Or Base COver daMaGe COuld resulT.

NOTE

3 inches M

fiGure 15: Headboard cross member location must not
exceed 3 inches (76.2mm) from the top of the mattress.

11. Install headboard brackets to the bed

base frame*. When attaching (2) twin
size units to a king size headboard an
optional swing hinge kit (see accessory
section) may be used to connect the twin
units.

Note: It is important to position the

bottom of the headboard cross member

a maximum distance of 3 inches

(76.2mm) between the headboard and

the top of the mattress (FIGurE 15). Do

not exceed 3 inches (76.2mm).

* S-cape™ and optima are Type A bed

base frames. Silhouette™, Profile, and

Pro-Motion™ are Type B bed base

frames.

Note: if adjustable bed is to be set up

without a headboard, basic installation

is now complete. If headboard is to be

installed, proceed to Headboard Bracket

Installation.

fiGure 14: Mattress retainer installed.