BenQ SP831 - Manual (Page 43)

Operation 43
Fine-tuning the selected picture mode
The pre-defined picture mode settings can be altered via the available items shown in the
Picture -- Basic and Picture -- Advanced menus.
To fine-tune the picture mode:
1.
Press MENU and then press / until the Picture -- Basic or Picture -- Advanced
menu is highlighted.
2. Press to highlight the item you want to adjust (from among Brightness, Contrast,
Color, Tint, Sharpness, Color Temperature, Clarity Control, Gamma Selection, Color
Management) and press /
to set your desired value. Your selection is
automatically stored in the projector and associated with that input source.
See
"Fine-tuning the picture quality" on page 45 and "Advanced picture quality
controls" on page 46 for details.
Each time you change the picture mode, the projector also changes the setting to the one
which was last set for that particular picture mode on that particular input. If you change the
input source, the most recently used picture mode and settings for that input and resolution
will be restored.
Setting the User 1/User 2/User 3 mode
There are three user-definable modes if the current available picture modes are not suitable
for your need. You can use one of the picture modes (except the selected User mode) as a
starting point and customize the settings.
1.
In the Picture -- Basic menu, highlight Picture
Mode and press
/ to select User 1, User 2, or
User 3 mode.
2. Press to highlight Load Settings From.
This function is only available when User 1,
User 2, or User 3 mode is selected up in the
Picture Mode sub-menu item.
3. Press ENTER to display the Load Settings From
page.
4. Press to highlight a picture mode that is closest
to your need and press ENTER and EXIT.
5. Press to select a sub-menu item to be changed
and adjust the value with
/ . See "Fine-
tuning the picture quality" on page 45 for details.
6. When all settings have been done, press MENU to
save and leave the settings.
Picture Mode
Load Settings From
Brightness
Contrast
Tint
Sharpness
Reset Picture Settings
Rename User Mode
Picture -- Basic
Analog RGB
User 1
EXIT Back
ENTER
Presentation Mode
Blackboard Mode
ENTER
EXIT Back
Load Settings From
Cinema Mode
Dynamic Mode
sRGB Mode
User 1
User 2
User 3
+50
0
Color
+50
+50
+50