BenQ SP831 - Manual (Page 34)

34 Operation
7. You have successfully assigned a new password to
the projector. Remember to enter the new
password next time the projector is started.
8. To leave the OSD menu, press MENU.
Disabling the password function
To disable password protection, go back to the
Advanced Setup > Password > Password menu.
Highlight Password and select Off by pressing
/ .
The message 'Input Password' displays. Enter the
current password.
• If the password is correct, the OSD menu
returns to the Password page with 'Off' shown
in the row of Password. You will not have to
enter the password next time when turning
on the projector.
• If the password is incorrect, the password
error message displays lasting for three
seconds, and the message 'Input Password'
displays for your retry. You can either press
MENU to cancel the change or try another
password.
Note that though the password function is disabled,
you need to keep the old password in hand should you
ever need to re-activate the password function by
entering the old password.
Password Changed
Password
Password
Change Password
On
EXIT Back