Konica Minolta bizhub C550 User Manual

Page 189

Administrator mode

C550

3-82

Reminder

In order to apply the changes to the settings for items which are marked
with an asterisk (*), restart the machine (turn it off, then on again).

When the machine is turned off, then on again, turn the machine off with
the [Power] (auxiliary power) key before turning off the main power
switch. In addition, wait at least 10 seconds to turn the machine on after
turning it off; otherwise, the machine may not operate correctly.

When using this machine under the IPv6 environment, there are the following
restrictions.
-

Printing using SMB is not available (available for direct hosting service).

Item

Description

TCP/IP*

Select whether or not TCP/IP is used.

Network Speed

Select the operating speed.

IP Address Setting Meth-
od*

Select whether the IP address is automatically acquired or is direct-
ly entered. If it is automatically acquired, select the check boxes to
specify the acquisition conditions.

IP Address

Specify the IP address of the machine. (Format: ***.***.***.***; Range
for ***: 0 to 255)

Subnet Mask

Specify the subnet mask of the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)

Default Gateway

Specify the default gateway for the connected network. (Format:
***.***.***.***; Range for ***: 0 to 255)

IPv6

Select whether or not IPv6 is used.
If “ON” is selected, specify settings for the following.
• Auto IPv6 Setting*
• Global Address
• Prefix Length
• Gateway Address

RAW Port Number

Select the check box for the port to be used, and then type in the
port number. (Range: 1 to 65535)

Dynamic DNS Setting

Select whether or not Dynamic DNS is enabled.

Host Name

If Dynamic DNS is enabled, type in the host name (up to 63 charac-
ters).

DNS Domain Name Set-
ting

Select whether or not the DNS domain name is automatically ac-
quired. If it is not automatically acquired, type in the domain name
below (up to 253 characters).

DNS Server Setting

A maximum of three DNS server addresses can be registered. (For-
mat: ***.***.***.***: Range for ***: 0 to 255)
If the machine is set to use IPv6, an IPv6 address can also be spec-
ified.

SLP Setting

Select whether or not SLP is enabled.

LPD Setting

Select whether or not LPD is enabled.