Konica Minolta bizhub 552 - Manual (Page 42)

bizhub 652/552 4-3
4.1 General fax/scan operation 4
4
Configure the scan settings as needed.
% For details on the scan settings, refer to page 4-9.
% To cancel the settings, press the Reset key, and then configure the settings again.
5
Press the Start key.
The original is scanned and the data is sent.
% To temporarily stop the scan operation, press the Stop key.
Reference
- Some settings cannot be combined with each other. If they are combined improperly, the settings will
be given priorities in either of the two ways described below.
– The setting configured last is given priority. (The setting configured first is canceled.)
– The setting configured first is given priority. (A warning message appears.)
- If an original with copy guard patterns embedded is scanned, the scan operation is stopped and the
job is discarded.
- If an original with a password embedded by the password copy function is scanned, the data is sent
after you enter the password.
- If multiple originals with different passwords are scanned at the same time, you will need to enter a
password for each original.