Audiovox Satellite Radio Receiver - Manual (Page 16)

16
Basic Operation
With the Xpress XM® unit properly installed, activated and connected
to your home/vehicle audio system or boom box, proceed as follows:
Turning Xpress ON and OFF
Set up your Audiovox Xpress XM® unit using the installation
instructions included in this Kit (Home Kit, or Boom Box Kit), or with the
help of a professional installer.
NOTE: Refer to Antenna Aiming during the installation procedure.
Press the Power button to turn the unit ON. When the unit turns ON the
XM® logo will appear for 3-seconds (curved lines on either side of the
XM® logo gradually appear) (see Figure 4) followed by the Audiovox
logo. These screens will be followed by the active channel (see Figure
5), which defaults to the last tuned channel setting prior to power being
turned OFF. When the unit is shut OFF the XM logo will appear and the
curved lines on either side of the XM® logo gradually disappear.
NOTE: If this is the first time using the Xpress XM® unit, the screen will
alternately display the preview channel screen and a number of
messages, including: “Activate Your XM® 1-800-XM RADIO”. If not, go
to channel 1 using the Rotary/Select Knob on the Xpress XM® unit or
the CH Up/Down buttons on the remote control.