Kramer Electronics VS-41HDCP - Manual (Page 31)

28 VS-41HDCP - Kramer Protocol
Command Name Short Cmd Command Type Permission
VID? V? Switch End User
Get Video Switch Stat
Syntax
#VID?␠out␍
#VID?␠ * ␍
Response
~nn@VID␠ in>out ␍␊
~nn@VID␠ in>1 , in>2 , … ␍␊
Parameters
in - input number or '0' to disconnect output
' > ' = Connection character between in and out parameters
out = Output number or '*' for all outputs
Command
Name Short Cmd Command Type Permission
ETH-PORT ETHP Ethernet Administrator
Change protocol Ethernet port
Syntax
#ETH-PORT
␠
protocol, port
␍
Response
~
nn@
ETH-PORT
␠
protocol, port
␠
OK
␍␊
Parameters
protocol = TCP or UDP (transport layer protocol)
port = Ethernet port that accepts Protocol 3000 commands:
1-65535 = User defined port
0 - Reset port to factory default (50000 for UDP, 5000 for TCP)
Notes
Device may get new setting only after restart or closing current port.
Some device port 50000 is the default also for TCP
Resetting port by value 0 may not work in all devices
For proper settings consult your network administrator
Command Name Short Cmd Command Type Permission
ETH-PORT? ETHP? Ethernet End User
Get protocol Ethernet port
Syntax
#ETH-PORT?
␠
protocol
␍
Response
~
nn@
ETH-PORT
␠
protocol, port
␍␊
Parameters
protocol = TCP or UDP (transport layer protocol)
port = Ethernet port that accepts Protocol 3000 commands.
Notes
Default Port is 50000 for UDP, 5000 for TCP
Some device has port 50000 as default also for TCP