Kramer Electronics VS-41HDCP - Manual (Page 14)

VS-41HDCP - Operating the VS-41HDCP 11
11
6.4 Controlling the VS-41HDCP via the ETHERNET Port
You can connect the VS-41HDCP via the Ethernet, using a crossover cable (see
Section ‎6.4.1 ) for direct connection to the PC or a straight through cable (see
Section ‎6.4.2 ) for connection via a network hub or network router.
6.4.1 Connecting the ETHERNET Port directly to a PC (Crossover
Cable)
You can connect the Ethernet port of the VS-41HDCP to the Ethernet port on your
PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory
default IP address of the VS-41HDCP during the initial configuration.
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select Properties.
3. Right-click Local Area Connection Properties.
4. Select Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button (see
Figure 5 ).
i