Australian Monitor AMD P Series - Manual (Page 19)

Specification Conditions
Frequency Response 70Hz - 20kHz, ±3 dB Signal Input 2 dB below clip
Total Harmonic Distortion < 0.6dB Signal Input 2 dB below clip
Input Impedance 11 kOhms
Nominal Input +1 dBu Rear panel level controls at maximum,
DSP bypassed
Crosstalk > 60dB 1 kHz, maximum output
S/N Ratio > 100dB A-weighted, 20 Hz to 20 kHz
Power Source AC Mains (110-120 V 60Hz / 220-240 V 50Hz) Factory Configured
24VDC Battery Backup
Recommended Operating Temp 10° C to 45° C (50° F to 113° F)
Recommended Operating Humidity 5 % to 95 % non-condensing
Dimensions (w x d x h) 433 mm x 442 mm x 43.6 mm Not including rack ears or
(17.0” x 17.4” x 1.7”) rear panel connectors
Shipping Dimmensions (w x d x h) 555 mm x 555 mm x 170 mm
(22” x 22” x 6.7”)
AMD2100P AMD2200P AMD4100P AMD4200P
Power Output
4 ohm 100W (20 Vrms) 200W (28.3 Vrms) 100W (20 Vrms) 200W (28.3 Vrms)
70 V 100W (49 Ohms) 200W (25 Ohms) 100W (49 Ohms) 200W (25 Ohms)
100 V 100W (100 Ohms) 200W (50 Ohms) 100W (100 Ohms) 200W (50 Ohms)
Power Consumption
Standby 7 W 12 W 12 W 13 W
Idle 11 W 20 W 20 W 30 W
1/8 power 48 W 92 W 92 W 160 W
1/3 power 107 W 204 W 204 W 364 W
Thermal Dissipation
Standby 7W (23.88 Btu/Hr) 12W (40.94 Btu/Hr) 12W (40.94 Btu/Hr) 13W (44.36 Btu/Hr)
Idle 11W (38.53 Btu/Hr) 20W (68.24 Btu/Hr) 20W (68.24 Btu/Hr) 30W (102.36 Btu/Hr)
1/8 power 23W (78.48BTu/Hr) 67W (228.60 BTu/Hr) 67W (228.60 BTu/Hr) 135W (460.62 BTu/Hr)
1/3 power 40W (137.62 Btu/Hr) 137W (468.58 Btu/Hr) 137W (468.58 Btu/Hr) 297W (1014.50 Btu/Hr)
Net Weight 10kg (22.0lb) 11kg (24.2lb) 13kg (28.6lb) 16kg (35.2lb)
Shipping Weight 13kg (28.6lb) 15kg (33.0lb) 16kg (35.2lb) 19kg (41.8lb)
PAGE 19 AMD SERIES INSTALLATION AND OPERATION MANUAL
SPECIFICATIONS