Innotech Device Communications - Manual (Page 31)

Page 23
Chapter 4 – Configuring Ethernet settings of Innotech devices
DS 99.05 – Ethernet Setup Manual for Device Communications 4
Refer to Figure 4-18 and the table below for detailed information to help you configure 3.
the IG01 to suit your LAN requirements.
Callout Area on the screen Description
Address Type
Always select Static to avoid network communication
problems, or problems communicating with the iComm
software.
IP Address
Enter the static IP address you want to assign the IG01
as per your LAN requirements.
NetMask Enter the subnet mask as per your LAN requirements.
Apply
When you have entered the desired Ethernet settings,
click on
Apply to save the new settings.
1
2
3
4
Configure Ethernet settings of IG01 Figure 4-18:
1
2
3
4
When the new settings have been applied, Status: Done will be displayed at the bottom
left corner of the IG01 web page.
If you are having difficulty accessing the IG01 embedded web server at any point, refer to
Chapter 5 – General Troubleshooting for general troubleshooting information.
NOTE
Please note that when the IP address of your device is changed and saved as described here, you may
have to modify your computer network settings to be on the same network range as your device if it is
different. You can then access the embedded web server by entering the new IP address assigned to
your device into the browser address bar.