Heading1 - 1.7 on-screen icon descriptions, Tabletitle - table 2. icons and their descriptions, Heading1 - 1.8 changing the power settings – In-Situ Con TROLL PRO Operators Manual (purchased before 10 May 2012) User Manual

Page 8: Heading1 - 1.9 set the polling (update) interval, 7 on-screen icon descriptions, 8 changing the power settings, 9 set the polling (update) interval, 10 setting the communications preferences, Instruments only)

Getting Started

1.7

ON-SCREEN ICON DESCRIPTIONS

1.8

CHANGING THE POWER SETTINGS

To conserve power, you can set the controller to turn off its display after idling for a
certain length of time.

1. On the Main menu, select Settings, Power Save.
2. Select one of the following options:

• External—The length of time that the display will remain on when powered

by the external DC battery or AC power.

• Battery—The length of time that the display will remain on when powered by

the C-cell batteries inside the controller.

3. Select the appropriate interval—Off (always on), 15 sec, 30 sec, 1 min, 5 min,

15 min.

1.9

SET THE POLLING (UPDATE) INTERVAL

The polling interval specifies how often the Con TROLL PRO checks the probes
and updates the configured outputs. On versions with the logging option, the polling
interval also sets the logging interval. The default logging/polling rate is every 15
minutes. Logging is automatic.

1. On the Main menu, select Settings, Polling Interval.
2. Select the desired interval and select Enter.

Note! Any change to the configuration of the parameters (add probe, delete
probe, enable/disable parameters, change units, etc.) will cause the data log
to be erased and restart.

1.10

SETTING THE COMMUNICATIONS PREFERENCES

1.10.1

Setting the Device Address for the Controller (RS485 Instruments Only)

Note: The address of Probe
A is the controller address
plus 1. The address of Probe
B is the controller address
plus 2.

1. On the Main menu, select Settings, Communication.
2. Select Address.
3. Enter a value between 1 and 245.

Table 2. Icons and their descriptions

Error with parameter

Battery remaining

Calibration stabilizing

Calibration nominally stable

View

Bluetooth

wireless technology turned on

Communication ongoing

View locked

View is not locked

Factory calibration for Level or Aqua TROLL probe has expired or RDO cap has expired.

User calibration has expired, based on the “Calibrate Interval¨.

Probe A not talking

Probe B not talking

Relay 1 active

Relay 2 active

This manual is related to the following products:

Con TROLL PRO