4 memory module replacement, Emory, Odule – IEI Integration EP-308A v1.12 User Manual

Page 82: Eplacement, Figure 4-1: bottom cover retention screws

EP-308A POS

Page 72

Figure 4-1: Bottom Cover Retention Screws

4.4 Memory Module Replacement

The flat panel PC has a preinstalled memory module. If the memory module fails, take the

steps below to replace it.

Step 1:

Remove the back cover. See Section 4.3 above.

Step 2:

Locate the memory module on the motherboard of the flat panel PC

Step 3:

Remove the memory module by pulling both the spring retainer clips outward

from the socket.

Step 4:

Grasp the memory module by the edges and carefully pull it out of the socket.

Step 5:

Install the new memory module by inserting it at an angle, then pushing down

until the clips snap into place (Figure 4-2).

Step 0: