2 compactflash® installation, Figure 2-2: aluminum back cover retention screws, Figure 2–3: compactflash® install – IEI Integration EP-308A v1.12 User Manual

Page 21

EP-308A POS

Page 11

Step 1:

Slice the hard drive on to connect with the SATA connector.

Step 2:

Fasten the screws.

Figure 2-2: Aluminum Back Cover Retention Screws

2.3.2 CompactFlash® Installation

This section covers the installation of the CompactFlash® card.

Step 1:

Remove the screw that holds the CompactFlash® card slot cover is place.

Step 2:

Install the CompactFlash® card in the slot indicated below.

Figure 2–3: CompactFlash® Install

Step 3:

Replace the cover and fasten the screws.