IEI Integration EP-308A v1.12 - Manual (Page 23)

EP-308A POS
Page 13
2.5.1 LAN Connection Cable
The RJ-45 connectors enable connection to an external network. To connect a LAN cable
with an RJ-45 connector, please follow the instructions below.
Step 1: Locate the RJ-45 connector on the bottom panel.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the bottom panel. See Figure 2-5..
Figure 2-5: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the onboard RJ-45 port. Step 0:
2.5.2 RJ-45 to DB-9 Serial Cable Connection
The EP-308A has two serial device connectors on the bottom panel. The two serial device
slots (RJ-45) connect to a cable with a standard DB-9 connector at the other end (cables
included). Follow the steps below to connect a serial device to the EP-308A panel PC.
Step 1: Locate the RJ-45 connector . The location of the RJ-45 serial port connector is
shown in Chapter 2. The RJ-45 connectors for the serial ports can be identified
easily as the RJ-45 for the network has two LEDs on the port, while the
connectors for the serial cables don’t.
Step 2: Insert the RJ-45 to DB-9 cable.