IEI Integration PPC-37xx-N270 v2.00 - Manual (Page 72)

PPC-37xx-N270 Panel PC
Page 58
Step 2: Slide the rear chassis through the rack/cabinet bracket until the rear side of the
LCD screen frame is flush against the front of the bracket.
Step 3: Make sure the retention screw holes at the rear of the LCD screen are aligned
with the retention screw holes in the rack/cabinet bracket.
Step 4: Secure the rack/cabinet bracket to the PPC-3712A/B-N270 flat panel PC by
inserting the retention screws (Figure 4-33).
Figure 4-33: Secure the Rack/Cabinet Bracket
Step 5: Follow Step 4 and Step 5 of the PPC-3708A-N270 Cabinet and Rack
Installation procedures to complete the whole installation process. Step 0:
4.12 Rear Panel Connectors
4.12.1 Keyboard and Mouse Connection
Two PS/2 connectors on the bottom panel facilitate the connection of a mouse and a
keyboard. To connect either device, plug the PS/2 connector at the end of the device
(keyboard or mouse) cable into the PS/2 connector on the bottom panel.
4.12.2 LAN Connection
There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.