IEI Integration PPC-37xx-N270 v2.00 - Manual (Page 46)

PPC-37xx-N270 Panel PC
Page 32
4.5.3 PPC-3712 Back Cover Removal
The back cover is secured to the chassis with nine retention screws, six on the rear panel
and three on the top panel (Figure 4-3). Remove the nine retention screws and lift the
cover off the PPC-3712.
Figure 4-3: PPC-3712 Back Cover Retention Screws
4.6 Jumper Settings
The jumper settings are all described in Section 4.6. During normal installation, these
settings should not be changed
4.7 CompactFlash® Card Installation
To install the a CF Type II card onto the PPC-37xx-N270, please follow the steps below:
Step 1: Locate the CF card socket . Place the PPC-37xx-N270 on an anti-static pad
with the solder side facing up. Locate the CF card socket.
Step 2: Remove the CF card socket cover. The socket cover is secured to the chassis
with two retention screws. Remove the two retention screws to remove the
socket cover.
Step 3: Align the CF card . Make sure the CF card is properly aligned with the CF
socket.