3 arm mounting – IEI Integration PPC-37xx-N270 v2.00 User Manual

Page 68

PPC-37xx-N270 Panel PC

Page 54

Figure 4-28: Tighten the Panel Mounting Clamp Screws

4.11.3 Arm Mounting

The flat panel PC is VESA (Video Electronics Standards Association) compliant and can

be mounted on an arm with a 100 mm interface pad. To mount the flat panel PC on an arm,

please follow the steps below.

Step 1:

The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

NOTE:

When purchasing the arm please ensure that it is VESA compliant and

that the arm has a 100 mm interface pad. If the mounting arm is not

VESA compliant it cannot be used to support the flat panel PC.

Step 2:

Once the mounting arm has been firmly attached to the surface, lift the flat panel

PC onto the interface pad of the mounting arm.