IEI Integration PPC-37xx-N270 v2.00 User Manual

Page 67

PPC-37xx-N270 Panel PC

Page 53

Step 3:

Cut out a section from the panel that corresponds to the dimensions of the flat

panel PC chassis. The panel section that is cut out must be smaller than the size

of the aluminum frame that surrounds the 12.1” TFT LCD panel but just large

enough for the chassis to fit through (Figure 4-27).

Figure 4-27: Suggested Panel Cut Out Size for PPC-3712A/B-N270

Step 4:

Slide the panel PC through the hole until the aluminum frame is flush against the

panel.

Step 5:

Insert the panel mounting clamps into the pre-formed holes along the edges of

the chassis, behind the aluminum frame. There are a total of 8 panel mounting

clamps.

Step 6:

Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel (Figure 4-28).