IEI Integration PPC-37xx-N270 v2.00 - Manual (Page 52)

PPC-37xx-N270 Panel PC
Page 38
4.9 CD Drive Installation (PPC-3712A/B-N270 Only)
To install the CD drive into the PPC-3712, please follow the steps below:
Step 1: Attach the CD drive adapter to the CD drive by aligning the two retention screw
holes in the CD drive adapter with the retention screw holes on the rear side of
the CD drive. Place the two spacers between the CD drive and CD drive adapter.
Insert two retention screws into the adapter (Figure 4-12).
Figure 4-12: CD Drive Adapter Installation
Step 2: Remove the back cover. See Section 4.5 above.
Step 3: Remove the CD drive bracket from the PPC-3712A/B-N270. To do this, remove
three retention screws, two on the side panel and one inside the panel PC
(Figure 4-13).