4 so-dimm replacement, So-dimm, Eplacement – IEI Integration PPC-37xxA-N26 v1.00 User Manual
Page 73: Figure 4-1: so-dimm module location
PPC-37xxA-N26 Panel PC
Page 57
To access the panel PC internal components, the back cover must be removed. To
remove the back cover, please refer to Section
for back cover removal instructions.
4.4 SO-DIMM Replacement
Please read the warnings at the beginning of the previous section before attempting to
access any PPC-37xxA-N26 internal components.
To install/replace the SO-DIMM modules, please follow the steps below.
Step 1:
Remove the back cover (Section
Follow Steps 2 ~ 4 in Section 3.7 to release the motherboard from the panel
PC.
Step 3:
Locate the SO-DIMM module on the solder side of the motherboard.
Figure 4-1: SO-DIMM Module Location
Step 4:
Release the SO-DIMM module by pulling both the spring retainer clips outward
from the socket.
Step 5:
Grasp the SO-DIMM module by the edges and carefully pull it out of the socket.
Step 6:
Install the new SO-DIMM module by pushing it into the socket at an angle
(Figure 4-2).