IEI Integration PPC-37xxA-N26 v1.00 - Manual (Page 40)

PPC-37xxA-N26 Panel PC
Page 24
3.6.3 AT/ATX Power Selection Jumper
Jumper Label: JP3
Jumper Type: 2-pin header
Jumper Settings: See Table 3-4
Jumper Location: See Figure 3-4
The AT/ATX power selection jumper specifies the system power mode as AT or ATX.
Setting Description
Short 1-2 Use ATX power (Default)
Off Use AT power
Table 3-4: AT/ATX Power Selection Jumper Settings
Figure 3-4: AT/ATX Power Selection Jumper Location
3.6.4 Clear CMOS Jumper
Jumper Label: JP1
Jumper Type: 3-pin header
Jumper Settings: See Table 3-5
Jumper Location: See Figure 3-5
To reset the BIOS, move the jumper to the "Clear BIOS" position for 3 seconds or more,
and then move back to the default position.