GxT V055-01 Diagnostic Analyzer - Manual (Page 20)

20
The AutoTest is one of the best and fastest ways to
collect comprehensive engine performance data. The
analyzer will customize the AutoTest based on the
ignition type selected during Engine Setup.
The AutoTest sequence steps through the Starting/
Charging History, Ignition Primary, Secondary, and Power Balance tests, and finishes with the Electronic
Compression test. Each of the tests is described in detail in the Engine Testing section of this manual,
and can be run individually at any time.
Make sure the engine is warmed up and running, and that all necessary test leads are connected. Enter
the AutoTest, as described above, and follow the instructions. You will be prompted to perform a variety of
actions during the test sequence, like cranking the engine during the Starting/Charging History or pressing
the NEXT key to continue a test after an action is performed. The EngineLink will do the rest, and will
print a detailed report at the end of the test.
Run Auto-Test
Auto-Test Configuration
Print Saved Data
Whenever a test is run, individually or as part of an
AutoTest, the results are saved for review and printout.
The resulting printed report will include the most recent
test readings along with any generated diagnostic
messages. If no tests have been done, a message will
advise that no data is available for printing. Disconnecting
power will erase all saved data.
You may choose what tests you want to make up and
an Autotest.
The first screen allows you to choose the tests that you
want to run for a Distributor Engine. Use the Arrow
buttons to move the selection arrow to the test you want
to be part of the Autotest. Press NEXT to make the
selection and move to the second screen
Use the Arrow buttons to move the selection arrow to
the test you want to be part of the Autotest. Press NEXT
to make the selection. A check mark will appear next to
the tests what will be included in the Autotest.
Once you are done, press the MENU key to save the changes.