GxT V963-01, C.O.P. Primary Adapter, 10 Cyl - Manual (Page 2)

• Always wear eye protection when testing vehicles. Be extra careful near batteries and moving parts. Do not lay tools
on a battery.
• Battery gas is highly explosive.
a. If a battery explodes flush the acid away from persons skin with generous amounts of water. Follow up with a
neutralizing solution of baking soda and then more water.
Treat clothing, vehicle parts, and equipment similarly. Any acid traces inside equipment must be removed by
generous rinsing. Dry equipment and place in a warm 50°C (120°F) oven until thoroughly dry.
b. Never use a wrench on the ungrounded battery terminal until the grounded one has been disconnected. Contact
between the vehicle body metal and the hot terminal can cause sparks to ignite gas or even weld tools into a
battery short circuit.
c. Keep the space around a battery well ventilated.
d. Do not make sparks or allow flames near batteries.
• Before working on a vehicle set the brakes and block the wheels. Beware of automatic parking brake releases.
• Keep your work area well ventilated and free of exhaust. Engine exhaust contains deadly poisons. Treat Gas Detector
exhaust and drain hoses the same as the vehicle tailpipe. Both give off deadly exhaust fumes.
• Avoid electrical shocks caused by getting close to live ignition wires or touching the coil TACH terminal. A person’s
reaction near a live engine can be more damaging than the shock.
• Keep spark producing devices at least 0.5m (18”) above the floor to reduce the hazard of igniting gasoline vapor.
• Do not let test leads wind up in a moving fan or pulley. Route leads away.
• Remove finger rings and metal wrist bands. They can short terminals and become very hot from electric current.
Technical Support & Service
Warranty
Questions or inquiries about service can be answered by contacting GxT, Inc., at: Toll Free (800) 627-5655. Fax: (231) 627-
2727, or [email protected]. When sending an item to the factory address it to: GxT, Inc., 520 MM Riggs Drive., Cheboygan,
MI 49721-1061. Include a note describing the problem.
FERRET BRAND LIMITED PRODUCT WARRANTY
GxT, Inc. of Cheboygan Michigan, warrants to the original purchaser that FERRET brand products are free from
defects in materials and workmanship for a period of two years from date of purchase. Our sole obligation for a
product within the above warranties will be to repair or replace, at our option, any defective parts and return the
product to the sender within the U.S.A., shipping prepaid, if it is sent to our Repair Department shipping prepaid
and accompanied by proof of purchase.
This Warranty does not apply to products which have been altered outside the factory; or repaired by anyone other
than the factory or its authorized service centers; or which have been damaged from accidents, negligence, or
abuse; or have been used differently than described in the printed instructions. Please note that wear and tear on
leads and replacement of consumable items such as: NOx Sensors, Oxygen Sensors, and paper, is not covered
by warranty.
GxT Inc.’s sole liability and buyer’s exclusive remedy is limited to repair or replacement of the product as stated
in the Limited Product Warranty. THERE ARE NO OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUD-
ING THOSE OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AND GxT, INC. SHALL
NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE SALE OR USE
OF THE PRODUCT.
Some states do not allow limitations on the length of implied warranties nor exclusion or limitations of incidental
or consequential damages, so that the above limitations and/or exclusion may not apply to you.
This warranty gives you specific legal rights and you may also have other rights which may vary from state to
state.
E963-01G
Safety Precautions