Garmin GNS 530 - Manual (Page 172)

GNS 530(A) Pilot’s Guide and Reference 190-00181-00 Rev. H 10-12
SECTION 10
AUX PAGES
If a ‘WARN’ annunciation appears at the
bottom left corner, GPS satellite coverage may
be sufficient, but the GNS 530 has detected a
position error which exceeds protection limits.
In this condition, all GPS navigation data on the
GNS 530 is disabled. Use an alternate navigation
source.
• Software Versions - Provides software version
information for the operating software within
the GPS receiver, COM transceiver, and main
processor board.
• Database Versions - Displays the current Jeppesen
database type and expiration date, along with the
version and type of built-in land database.
• Terrain Database Versions - Displays the current
version and area of coverage of each terrain and
obstacle database. If a database is found to be
missing and/or deficient, the TAWS system fails
the self-test and issues a failure message.
Utility Page: Checklists
Creating a checklist:
1) Select ‘Checklist’ from the Utility Page using
the steps described at the beginning of this
section (10.3). Press the ENT Key to display a
list of checklists.
2) Press the MENU Key to display the Checklist
Page Menu (Figure 10-18). Turn the large
right knob to select ‘Create New Checklist?’
and press the ENT Key.
Figure 10-18 Checklist Page Menu
3) Use the small and large right knobs to enter
the name of a checklist. Press the ENT Key
when finished. (Up to nine different checklists
can be created and stored in the GNS 530.)
4) Use the small and large right knobs to enter
each checklist item, followed each time by the
ENT Key. Each checklist may contain up to 30
line items of as much as 16 characters long.