Yamaha EMX120CD - Manual (Page 36)

E-28
Automatic preset tuning
You can make use of an automatic preset tuning function.
With this function, this unit performs automatic tuning and
stores stations with strong signals sequentially. Up to 40
stations are stored automatically in the same way as in the
manual preset tuning method on the previous page.
1
Select the tuner by pressing the TUNER INPUT
SELECTOR button so that “TUNER” appears on the
display.
2
Press and hold the tuner MEMORY button for more than
2 seconds.
* The MEMORY and AUTO indicators flash.
This unit performs automatic tuning and searches FM and
AM stations in that order. Received stations are programmed
to A1, A2 ... A8 sequentially.
When the automatic preset tuning is completed;
The display shows the frequencies of the first preset station
(stored to A1).
Check the contents and the number of preset stations by
following the procedure of the section “To recall a preset
station” on the previous page.
To recall a preset station
Simply follow the procedure of the section “To recall a preset
station” on the previous page.
Notes
•
The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If the
number of received stations is less than 40, the search will
stop after searching all frequencies.
* Since FM stations are searched for first, there may be a
case that 40 preset stations are occupied by FM
stations only.
• With this function, only stations with sufficient signal
strength are stored automatically. If the station you want
to program is weak in signal strength, tune in to it with the
Manual tuning method (in monaural) and program it by
following the procedure of the section “To store stations”
on the previous page.
• You can replace a preset station with another FM or AM
station manually by simply following the procedure of the
section “To store stations” on the previous page.
CD CHANGER RECEIVER EMX–120CD PRESET/TUNING/BAND A/B/C/D/E
OPEN/CLOSE
DISC 1 DISC 2 DISC 3
DISC CHANGE
VOLUME INPUT SELECTOR
VCR•LD/TV•CD•TAPE/MD•TUNER
CD TUNER
STANDBY/ON
PHONES
KARAOKE
PROGRAM
MEMORY
MUSIC
DISPLAY MEMORY AUTO/MAN’L REPEAT TIME
TIME ADJ TIMER HOUR MIN
INPUT TRIM MIC TONE MIC MIC MIXING
SOFT NORMAL MAX MIN
ECHO ECHO
TUNING OPERATION
TIME
A
PROG
B C D
+ I0
E
CD TUNER
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9 0
PRESET
INPUT
MUSIC PROGRAM
STANDBY/ON
DISPLAY SLEEP
ECHO
FLAT
LEVEL KARAOKE
VOLUME
DISC SKIP STOP PLAY/PAUSE
TUNER CD
TEST
CENTER/REAR
/DELAY
OPEN/CLOSE REPEAT RANDOM MODE
2 1
1
Memory back-up
The memory back-up circuit prevents the programmed
data from being lost even if the AC supply lead is
disconnected from the AC outlet or the power is cut due
to temporary power failure. If, however, the power is cut
for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the
preset tuning steps.