Yamaha EMX120CD - Manual (Page 27)

E-19
English
TIME
A
PROG
B C D
+ I0
E
CD TUNER
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9 0
PRESET
DISC SKIP STOP PLAY/PAUSE
OPEN/CLOSE REPEAT RANDOM MODE
COMPACT DISC PLAYER OPERATION
PLAYXCHANGE
During playback, you can open the disc table by pressing the
DISC CHANGE button without interrupting playback.
However, in this case, pressing the DISC SKIP button or a
DISC selector button is invalid.
Note
You can load or replace discs on the trays when the disc
table is opening, however, never load a disc on the tray
hidden inside the unit. In doing so, the disc and the unit may
be damaged, because the tray already has a disc, which is
being played back.
Precautions
• Subjecting the unit to shock or vibration can cause
mistracking.
• Playing back some compact discs at high volume can
cause mistracking. In this case, listen at lower volume.
• Do not pull open the disc table forcibly with your hands.
• Do not push the disc table while it is moving.
• If the power fails while the table is open, wait until the
power supply returns or gently push the table manually to
close it.
• The temperature range for playing back compact discs is
recommended to be 5°C (41°F) – 35°C (95°F).
Direct operation
When this unit is in the standby mode, pressing the following
buttons will turn the power on and perform their own
functions automatically.
On the front panel: OPEN/CLOSE, DISC (1, 2, 3),
INPUT SELECTOR (CD, TUNER)
On the remote control transmitter:
OPEN/CLOSE, CD, TUNER,
PLAY/PAUSE
Direct-selection playback
By using the track number input buttons on the remote
control transmitter, any track you wish to listen to can be
played back directly.
Use the track number input buttons to select the desired
track number. Playback will begin automatically.
A. For example, to choose selection 5
Press the “5” button.
B. For example, to choose selection 12
(1) Press the “+10” button.
(2) Within a few seconds, press “2” button.
C. For example, to choose selection 20
(1) Press the “+10” button.
(2) Within a few seconds, press the “+10” button again.
(3) Within a few seconds, press the “0” button.
Note
If you select a track number higher than the number of tracks
on the disc, only the last track of the disc may be played
back.
To interrupt playback
1 1
Press the play/pause / button.
* The “ ” indicator will flash.
2 2
Press the play/pause / button to resume playback
from the same point.
To stop playback
Press the stop button.
To turn the unit into the standby mode after use
Turn this unit into the standby mode by pressing the
STANDBY/ON switch. (The indicators will go off except for
the current time display.)
Direct playback
When this unit is in the standby mode, pressing the DISC
selector (1, 2 or 3) button will turn the power on and start CD
playback automatically.
When the power is on, even if an input source other than CD
player is selected, pressing a DISC selector button or closing
the disc table by pushing the front edge of the disc table
gently will start playback directly.
* These ways of playback can also be used to close the disc
table. If the table is closed in these ways, playback will
begin automatically, however, the display will not show the
total number of tracks and the total playing time of the disc
to be played back.