Disconnecting the unit from your computer, Recharging the eneloop, Before recharging the eneloop – Yamaha POCKETRAK 2G User Manual
Page 38
Connecting to a Computer
38
POCKETRAK 2G Reference Manual
Disconnecting the unit from your computer
Before disconnecting the unit from your computer, make sure that no data is being trans-
ferred.
Follow the steps below to disconnect.
1.
Right-click the device icon on the taskbar at the bottom right of the Win-
dows screen to pop up the menu option [Safely Remove Hardware].
If the icon is not displayed, refer to Windows Help.
2.
Click [Safely Remove Hardware].
3.
Select [USB Mass Storage Device] and click [Stop].
4.
Make sure that [Yamaha Pocketrak USB Device] is in the list, then select [USB
Mass Storage Device] and click [OK].
5.
Disconnect the unit from your computer.
Recharging the eneloop
• Be sure to insert and recharge the eneloop. Do not attempt to recharge alkaline bat-
teries. Otherwise, the battery liquid may leak and damage the unit.
• Recharge the eneloop at an ambient temperature between 5 and 35 degrees Celsius
(41 and 95 degrees Fahrenheit).
Before recharging the eneloop
• Make sure that the BATTERY SETTING is set to “eneloop.” (
)
• Be sure to close the battery cover before you start recharging.
Recharging the eneloop
1.
Connect the unit to your computer. (
2.
While the LCD screen on the recorder indicates that
the unit is connected to the computer, press the Y
button for at least two seconds.
The REC/PEAK LED lights up and recharging starts. When
the battery is recharging, the battery indicator on the LCD
screen changes in the following sequence:
When recharging is complete, the REC/PEAK LED turns off.