Quantum Internal Storage System Travan 40 GB - Manual (Page 15)

Installing the Drive
Installation Procedure
Quantum Travan 40 GB Internal Storage System 11
Figure 8 Use a Mew
40-Pin IDE Cable
In either case, make sure that pin 1 on the tape drive (located next to
the power connector) is connected to pin 1 on the IDE cable and on
the IDE port connector. Pin 1 on the IDE cable is indicated by a stripe
on the edge of the cable.
6
Connect the power cable
Connect a 4-pin power cable to the back of the tape drive (see
figure 9 ). If all the power cables in your computer are being used by
other devices, you can purchase a Y-shaped power-cable splitter from
your computer dealer.
Figure 9 4-Pin Power
Cable Connection
TAPE
Computer
Motherboard
Primary
IDE port
Secondary
IDE port
Hard
Disc
Hard
Disc
Pin 1 (typical)
Stripe
on
cable