Quantum Internal Storage System Travan 40 GB - Manual (Page 14)

Installing the Drive
Installation Procedure
10 Quantum Travan 40 GB Internal Storage System
5 Attach your tape drive to the secondary IDE port
Are any other devices attached to your secondary IDE port?
If you already have a CD-ROM or other device attached to your
secondary IDE port, attach the tape drive to the middle connector on
the IDE cable (see figure 7 ).
Figure 7 If a CD-ROM
is Attached, Attach the
Tape Drive to the
Middle Connector
If no other devices are attached to your secondary IDE port, use a
new 40-pin IDE cable to attach the tape drive to the secondary IDE
port (see figure 8 ).
Note:
Do not attach your tape drive to a cable that is already
being used by a hard disc or a sound card.
Computer
Motherboard
Primary
IDE port
Secondary
IDE port
Hard
Disc
Hard
Disc
CD-
ROM
CD-
ROM
Pin 1 (typical)
TAPE