NEC GT2000 - Manual (Page 34)

E-34
OPERATION 4
(OFF) (ON)
STATUS
POWER
ON / OFF
STATUS
POWER
ON / OFF
OFF ON
POWER
RGB1 RGB2 VIDEO/S-VIDEO
Each press toggles between S-
VIDEO and VIDEO.
VOLUME
The volume increases.
The volume decreases.
Volume
– + 32
General Controls
Getting started
This section describes the basic operation of the projector.
The operation may differ depending on the makeup of the
projector system; therefore, please follow the directions of
your system administrator.
Operation using the remote control is described here. The
following controls have the same function: the MENU button
of the main unit and that of the remote control, the SELECT
button of the main unit and the cursor button of the remote
control, the ENTER button of the main unit and the ENTER
button of the remote control.
1. Switch On the Main Power
Press the "1" side of the POWER switch located on the front
of the main unit.
The POWER indicator will light up orange and the unit will
be set to the standby mode.
When the STATUS indicator is lit or flashing, see Page E-77.
2. Switch On the Power
Press the POWER (ON/OFF) button.
The lit POWER indicator will change to green and the power
will be switched on.
Press the POWER ON button.
3. Select the Input
Select the desired input connector.
Select the desired input connector.
Directly specify and call the list of user memories in which
the input signals and screen adjustment conditions have al-
ready been registered.
This function is valid when the on-screen menu is not dis-
played.
• Calling (Loading) Memory Lists "00 to 09"
Hold down the CTL button and press the number keys
that correspond with the numbers.
(Remote control number buttons 0 through 9 correspond
with memory lists 00 through 09.)
• Calling (Loading) Memory Lists "00 to 99"
Use the number buttons to enter the numbers that corre-
spond with the memory lists, then press the LOAD
button.
When an entry mistake has been made, press the
CLEAR button.
* See "Data Reading of Registration Signals (Load)" on Page
E-60 when loading signal data while viewing the contents
from the on-screen menu display as well as when loading the
switcher signal data.
4. Adjusting the Volume of the Built-in Speaker
A press of the button will display the volume display for a
while.
* To set the volume display so that it does not appear, see
"Selecting the On-screen Display ON/OFF" on Page E-37.
* When the unit is connected with a switcher and [Audio
Control] is set to [On], the volume button of the projector will
control the volume of the equipment that is connected to
AUDIO OUT of the switcher.
The volume adjustment range is from 0 to 63.