NEC GT2000 - Manual (Page 25)

E-25
S-VIDEO INPUT AUDIO
VIDEO INPUT AUDIO
REMOTE 1
RGB 1 AUDIO
REMOTE 2/PC
EXT-CTL
RGB 2
AUDIO
AUDIO
OUTPUT
REMOTE
OUTPUT
REMOTE
INPUT L/MONO R L/MONO R
L/MONO R
R/Cr G/Y B/Cb H/HV V
RGB
INPUT 2
RGB
OUTPUT
Wiring Diagram
Document Camera
IBM VGA or Compatibles
Monitor
DVD Player or LaserDisc Player
Macintosh
ISS-6020
IPS-4000/
IPS4000Q
VCR/ Laser disc player
Connecting Your Document Camera
You can connect your MultiSync GT2000/GT2000R LCD Projector to a document camera. To
do so, simply:
1. Turn off the power to your LCD projector and document camera.
2. Use a standard video cable to connect your document camera to the Video input on your
projector.
3. Turn on the LCD projector and the document camera.
NOTE: Refer to your document camera's owner's manual for more information about your
camera's video output requirements .
Connecting Your VCR Or Laser Disc Player
Use common RCA cables (not provided) to connect your VCR or laser disc player to your
MultiSync GT2000/GT2000R LCD Projector. To make these connections, simply:
1. Turn off the power to your LCD projector and VCR or laser disc player.
2. Connect one end of your RCA cable to the video output connector on the back of your VCR
or laser disc player, connect the other end to the Video input on your projector. Use standard
RCA audio patch cords to connect the audio from your VCR or laser disc player to your
projector (if your VCR or laser disc player has this capability). Be careful to keep your right
and left channel connections correct for stereo sound.
3. Turn on the LCD projector and the VCR or laser disc player.
NOTE: Refer to your VCR or laser disc player owner's manual for more information about your
equipment's video output requirements.
Connecting An External Monitor
You can connect a separate, external monitor to your LCD projector to simultaneously view on
a monitor the image you're projecting. To do so:
1. Turn off the power to your LCD projector, monitor and computer, document camera or
video source.
2. Use a 15-pin cable to connect your monitor to the RGB Monitor Output (Mini D-Sub 15
pin) connector on your LCD projector.
3. Turn on the LCD projector, monitor and the computer, document camera or video source.
CONNECTIONS 3
External Control
Connecting Your PC Or
Macintosh Computer
Connecting your PC or Macintosh
computer to your GT2000/
GT2000R Projector will enable you
to project your computer's screen
image for an impressive presenta-
tion.
To connect to a PC or Macintosh,
simply:
1. Turn off the power to your pro-
jector and computer.
2. Use the signal cable that's sup-
plied to connect your PC or
Macintosh computer to the pro-
jector.
3. Turn on the projector and the
computer.
4. If the projector goes blank after a
period of inactivity, it may be
caused by a screen saver in-
stalled on the computer you've
connected to the projector.