No data can be written to a CD-RW disc that contains
data written by another device.
Failed while writing to CD.
→ Select an appropriate speed for writing to CD-R/RW.

If you failed while writing at the highest speed, try a
slower speed. In some cases if you are using a disc that
is optimized for high-speed writing, you may be una-
ble to write at low speeds.

→ Try a different disc.
Can’t select some speeds when writing to CD.
→ The speeds that you can select will differ depending on

the type of disc.

Can’t create an audio CD.
→ Use a blank disc.

Can’t play back on an audio CD player

Did you finalize the disc?
→ In the CD, Track at once page, click the Finalize button

to finalize the disc. (

→p.140)

Did you use CD-R disc?
→ Some CD players are unable to play back CD-RW

discs. We recommend that you use CD-R discs.

Have you tried using a different type of disc?
→ Even when the recommended media is used, some CD

players are unable to play back certain types of CD-R/
RW disc. You may be able to play back successfully if
you use a different type of CD-R/RW disc.

Audio files

Can’t preview

Is the audio file format supported?
→ Preview a WAV file of a supported format. (→p.86,

135)

USB

Computer does not recognize the D3200

Is the USB cable connected correctly? (

→p.12)

Is the D3200 set to USB Slave mode? (

→p.93)

Recognition may also fail on some models of Macintosh
for specific versions of the operating system. In this case,
leave the D3200 in USB mode, and disconnect and then
reconnect the USB cable so that the D3200 will be
recognized.

Error occurred when you disconnected the D3200
from the computer

Use the correct procedure to disconnect. (

→p.93)

When you connected the D3200, the computer
asked you to install software or a device driver

Does the operating system of your computer support the
D3200? (

→p.93)

Startup

The display hangs at “Start up from CD. Wait CD
Mount.” and startup does not occur

Use the recovery CD to start up the D3200. (

→p.96)

Troubleshooting