SUPER MICRO Computer MIIC-203 - Manual (Page 36)

37
Command: /H[0|1][CR] 'Hex Only Display [0 = Disabled, 1 = Enabled]
Response: * 'iPort/AFM Ready
Default Setting: Enabled
Set iPort/AFM’s Own I
2
C Slave Address
This command sets iPort/AFM's own I
2
C Slave Address (Hex 2...FE). Subsequent
I
2
C messages to this address will cause iPort/AFM to become an active Slave device
on the bus.
Command: /Ixx[CR] 'Set iPort/AFM’s Own I
2
C Slave Address
Response 1: * 'iPort/AFM Ready
Response 2: /I89[CR] 'Invalid Command Argument
Default Setting: 6E
I
2
C Bus Clock Rate Control
Set the I
2
C Bus master clock rate.
(0=23, 1=86, 2=100, 3=400KHz)
Command: /K[0|1|2|3][CR] 'Set iPort/AFM’s Clock Rate
Response 1: *
Default Setting: /K2[CR]
The iPort/AFM clock rate for standard commands is controlled by the oscillator
crystal we use on our microcontroller. This crystal has been selected to give accurate
RS-232 baud rates, as the RS-232 baud rate must exactly match the rate used by the
host computer. Master I2C clock rates are the fastest possible given the required
crystal frequency. Slave I2C clock rates are driven by the external master device,
with possible clock-stretching as required to store or retrieve message data.
Command Menu Display
This command displays iPort/AFM’s command menu.
Command: /M[CR] 'Command Menu Display
Response:
iPort/AFM Command Menu Syntax: [Select], (Optional), xx=[00..FE], n=[1..32767]