SUPER MICRO Computer MIIC-203 - Manual (Page 32)

33
/N( [0|1|A|R] )[CR] iNterrupt Signal Monitor/Control/Status
Sets Monitor/Control/Status of INT line.
[0 = Disable, 1 = Enable, A = Assert, R = Release/CR=Status]
/O[CR] Open I
2
C Connection
Activates iPort/AFM as an I
2
C device attached to the bus.
/(*)Rn[CR] Master Read Message
Read the specified number of data bytes from the current Destination I
2 C
Slave device. * = No Stop for Repeated Start
/S(text)[CR] Slave Transmit Message
Write the specified data bytes to a requesting I
2 C Master Receiver device.
/(*)T(text)[CR] Master Transmit Message
Master Transmit the specified data bytes to the current Destination I
2
C
Slave device. * = No Stop for Repeated Start
/Un[CR] I 2 C Bus Time-oUt
Set I
2
C Bus Time-oUt in msec (0=Disable)
/V[CR] Display Firmware Version
(Major XX.XX Minor) (Requires Version 2.0 or later)
/X[CR] eXtended Commands
(See Prompt or User’s Guide) (Requires Version 2.0 or later)
/Y[CR] Display Tx bYte Count (Requires Version 2.0 or later)
Note: An online version of this programmer’s reference is available at: http://www.mcc-us.com/203ug.htm
Synchronous Interface Events
Synchronous Events are those iPort/AFM interface activities initiated by the Host
computer.
iPort/AFM Reset
This command resets iPort/AFM to its default state.
This command consists of three (3) sequential Ctr/R characters.
Ctr/R is the character code Decimal 18 and Hexadecimal 12, and can also be
generated by holding down the Ctrl Key and pressing R.
Note: It is recommended that the Host computer turn off all serial port flow control
before sending this command. Flow control should be enabled once the response is
received.