Sony PRS-T1 - Manual (Page 145)

Do not use the Reader in humid locations or bad weather, such as in the rain or snow.
Do not get the Reader wet.
If you touch the Reader with wet hands, or put the Reader in a damp article of clothing, the
Reader may get wet and this may cause a malfunction.
Charging the Reader
Heat may build up in the Reader while charging, or if it is used for an extended period of time.
Use the supplied USB cable or the optional AC adapter (PRSA-AC10/PRSA-AC1A, sold
separately) only. Do not use other USB cable and AC Adapter.
Never wrap the Reader in anything when it is being charged. Heat build-up in the Reader may
cause malfunction or damage.
If the battery quickly runs out of power after being fully charged, it may be reaching the end of
its life and should be replaced. Consult Sony Support Center.
Road safety
Do not use headphones (not supplied) while driving, cycling, or operating any motorized vehicle.
It may create a traffic hazard and is illegal in many areas. It can also be potentially dangerous to
play at a high volume while walking, especially at pedestrian crossings. You should exercise
extreme caution or discontinue use in potentially hazardous situations.
Preventing hearing damage
Avoid using the headphones (not supplied) at a high volume. Hearing experts advise against
continuous, loud and extended play. If you experience a ringing in your ears, reduce the volume
or discontinue use.
Caring for others
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be
considerate to the people around you.
Warning for headphones (not supplied)
If lightning occurs while you are using the Reader, take off your headphones (not supplied)
immediately.
Wi-Fi connectivity
The Wireless LAN functionality has passed Wi-Fi certification and complies with the
interoperability specifications established by WFA (Wi-Fi Alliance).
Cleaning the Reader
Clean the Reader with a soft cloth, such as a cleaning cloth for eyeglasses. Make sure that
there is no dust or dirt on the soft cloth, as the Reader may be damaged.
Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or
benzene, as it may mar the finish of the case.
Wipe the stylus with a dry cloth when it gets dirty. Tapping or dragging on the touchscreen
using a dirty stylus may damage the surface.
Be sure to keep the Reader away from water or spills.
Touchscreen
Do not apply excessive pressure to the touchscreen. The color or lighting may become
145