Intellinet Network Solutions PRO SERIES INT-PSNC-UM-1106-06 - Manual (Page 45)

- 45 -
Trigger Output
This is to configure digital output states and control script. The Pro Series Network Camera
sends captured images via e-mail or an FTP server when connected external sensors detect
events.
Supply voltage to output port for xxx seconds
This is to supply voltage to the output port when events are triggered. (This option is only
activated when you select the "Activation of digital output" option in the "Trigger Condition"
section.) During the activation period, which you can specify in seconds, the camera provides
power to the GPIO connector in pins 3 and 4 – see Appendix F.
Send alarm to ETSP client
By checking the box, an alarm will be sent to the ETSP client when the events are triggered.
Refer to Section 9 for instructions on the ETSP client.
Send captured image to e-mail
This is to designate a person to receive captured images via e-mail through the SMTP server.
You may configure the SMTP server and e-mail address as desired.
Send captured image to FTP server
This is to send captured video from the camera when an event is triggered. Enter an FTP server
IP address, user ID and password, and select a directory to save video.
Image Capture option limitation
The configuration for the image capture option affects memory capacity. If the configuration uses
excessive memory, the warning message “Not enough memory…" will display. The total image
capture frame rate must be no more than 120 fps due to memory size.
(Before event time + After event time) x (Image capture frame rate) must be under 120.
For example, if “Before event time" is 3 seconds, “After event time" is 2 seconds and “Image capture
frame" is 3 fps, the total image capture frame rate is (3 + 2) x 3 = 15 fps.
If a warning message appears, reduce the value of the option.