IBM R/S Rheometer M/02-212 - Manual (Page 42)

Brookfield Engineering Labs., Inc. Page 42 M/02-212
After selection of the measuring system, you will be requested to input sequentially: its name, tau_prom
and k_gamma.
The measuring system name is a alpha-numerical entry, factors tau_ prom and k_gamma are input as
numerical entries (see Chapter 6.4).
When done, a security request follows, if you really want to save new parameters.
Using key you can save the changes, otherwise, using key you can return to the Menue,
without saving.
VI.6.5 Utilities → Print memory
This function serves output of measuring values from internal memory to the printer, connected to the
Rheometer, or to the serial interface RS232 of the Rheometer.
First, you will be requested to select the output device, where you want to transfer the measuring values
to.
a) Output to printer:
The printer must be connected to the Rheometer and be ready for operation.
b) Output to the serial interface RS232:
Data receiving device (mostly a PC) must be adjusted to same data transfer parameters as R/S
Rheometer and be ready for receiving data, because the data transfer of the Rheometer to the receiving
device is carried out without handshaking. If the receiving side is not ready or is not adequately tuned,
the data will be transmitted “into emptiness”. (See also Chapter 6.8 “Serial data transfer”).
Enter Meas. Sys. #4
Name: CP25
tau_prom: 01.1418
k_gamma: 01.2910
PRESS to save
Name: CC25
tau_prom: 01.1418
k_gamma: 01.2990
Sel. Output-device:
- Printer
- RS232 Output to printer
Output to RS232
serial interface
ST OK