Intelligent Motion Systems UDAS-1001E User Manual
Page 7

Table of Contents
ii
3.4.1.1 Verify Lower Level Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-13
Appendix A
Specifications
A.1
UDAS-1001E Series Hardware Specifications. . . . . . . . . . . . . . . . . . . . .
A-1
TABLE A.1
Hardware Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-1
A.2
UDAS-1001E-3, UDAS-1001E-4 Dimensions . . . . . . . . . . . . . . . . . . . . .
A-4
FIGURE A.1
Dimensions of the UDAS unit (Top view) . . . . . . . . . . . . .
A-4
FIGURE A.2
Dimensions of the UDAS unit (Rear panel) . . . . . . . . . . .
A-4
FIGURE A.3
Dimensions of the UDAS unit (Bottom view) . . . . . . . . . .
A-5
FIGURE A.4
Dimensional Drawing of the UDAS series PCB . . . . . . . .
A-6
A.3
UDAS I/O Connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-7
TABLE A.2
UDAS I/O Connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-7
Appendix B
Accessories
TABLE B.1
Accessories for the UDAS-1001E Series . . . . . . . . . . . . . .
B-1
B.1
UDAS Termination Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-2
B.1.1
PCI-20429T-1 Multifunction Termination Panel . . . . . . . . . . . . . . . . .
B-2
FIGURE B.1
Securing the PCI-20429T-1 to the UDAS unit . . . . . . . . .
B-2
FIGURE B.2
PCI-20429T-1 Multifunction Termination Panel . . . . . . . .
B-3
B.1.2
UDAS Termination and Signal Conditioning Options . . . . . . . . . . . . .
B-4
FIGURE B.3
UDAS-1001E Termination Options . . . . . . . . . . . . . . . . . .
B-4
FIGURE B.4
UDAS-1001E Termination Options (continued) . . . . . . . .
B-5
FIGURE B.5
Diagram of the PCI-20430A-1’s connectors and cables. .
B-6
B.1.3
Isolator Blocks. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-7
Appendix C
Analog Input and Output Calibration Procedures
C.1
UDAS Analog Input Circuit Calibration Procedures . . . . . . . . . . . . . . . . .
C-1
C.1.1 Removing the UDAS Unit’s Cover . . . . . . . . . . . . . . . . . . . . . . . . . . .
C-1
FIGURE C.1 Locations of Potentiometers for Adjusting Analog Circuits
C-2
C.1.2 Analog Input Calibration Procedure . . . . . . . . . . . . . . . . . . . . . . . . . .
C-3
C.2
UDAS Analog Output Circuit Calibration Procedure . . . . . . . . . . . . . . . .
C-6