FUJITSU M3097G User Manual
Page 149

f
Description
-
Upon receiving the detected paper information from the read command
(Data type code = Xπ81π), the driver or application software must specify
the window area (Set window command Byte 6 to 15) and the paper size
(Set window command Vender unique parameter byte 35) using the set
window command.
-
The detected paper information is accessed with the read command (Data
type code = Xπ81π).
-
Once paper is fed by issuing the object position (Unload object) command,
the direction to which paper is loaded (paper direction) is accessed with the
read command (Data type code = Xπ81π).
f
Job separation sheet
Byte 2
Xπ80π: Job separation sheet is detected.
Xπ00π: Job separation sheet is not detected.
f
Paper size
Byte 3
Reserved
Format of detected paper information
Reserved
Job separation sheet
Paper size
Reserved
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
Byte 7
b7
b6
b5
b4
b3
b2
b1
b0
Following paper size is detected.
0000: Undefined
1000: Undefined
0001: Undefined
1001: Undefined
0010: Undefined
1010: Undefined
0011: A3 or DL
1011: Undefined
0100: A4 or LT
1100: B4
0101: A5
1101: B5
0110: Undefined
1110: Undefined
0111: Undefined
1111: Undefined
0: Portrait
1: Landscape
0: Paper size detected, when the paper is fed from ADF.
1: Paper size not detected, when the paper is fed from ADF.
0: The Paper is loaded into ADF (Except 1st page).
1: The paper is ejected from ADF.
Note:
Bits 4, 5, and 6 are effective only when image data has been read. An ™*1∫ in
Figure 1.1.1 shows the effective timing.
D $ 4