Furuno FELCOM 16 - Manual (Page 102)

4. INMARSAT C OPERATIONS
4-8
TRANSMIT MESSAGE STATUS
The terminal unit displays transmit message status as follows:
Message Send failed. This appears if the message could not
be transmitted because of technical reasons such as satellite
malfunction, signal degradation, or no reply from LES. Try to
transmit the message again.
Message Send rejected. This appears when the LES rejects
the message because of non-technical reasons such as unpaid
subscriber's fee.
Message Send pending.This appears when the circuits at the
LES are busy. Your message will be transmitted when a circuit
becomes clear.
Transmitting a message to a station not registered on station list
1. Prepare message on the screen. For e-mail or SMS, set Text Mode in the
Editor Setup menu to Ascii. See paragraph 3.2.3. For e-mail attachment,
prepare the attachment and save it to the hard disk. SMS messages over
160 characters in length are sent in parts.
2. Press the [F3] key to display the Transmit menu.
3. Press the [1] key to show the Transmit Message menu.
25 Char. [ Line 2/ 2 Col. 1 ]
<[1] UNTITLED1>
----*---------+---------+---------+---------+---------+---------+---------<
[Insert ]
Transmit
1. Transmit Message
2. Cancel
3. Request Delivery Status
Transmit Message
Normal
Message now being edited Size 24
TELEX
ON
00:00
Immediate
IA5
File Edit Transmit EGC Reports Logs Options Setup Position StopAlarm
Priority
Message File
Station Name Cost ********.**(US$)
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
Attach File
LES ID
Option
Confirmation
Send Delay
Delivery Delay
Code
[ TRANSMIT ]
Displayed if toll charges have been entered. See para. 2.6.1.
Not used.
Transmit message menu