Hitachi VT-MX211A - Manual (Page 52)

TROUBLESHOOTING GUIDE
52
TROUBLESHOOTING GUIDE
If you have followed the instructions contained in this manual and have difficulty in
operating your VCR, locate the SYMPTOM in the left column below. Check the
corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the
problem.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
NO POWER TO VCR POWER CORD IS NOT
CONNECTED. CONNECT POWER CORD
TO AC OUTLET.
THE VCR POWER IS
TURNED OFF. PRESS POWER BUTTON TO
TURN ON THE VCR.
TIMER RECORDING IS NOT
POSSIBLE. THE TIMER RECORDING IS
SET INCORRECTLY. SET THE TIMER
RECORDING CORRECTLY.
THE VCR POWER IS
TURNED ON. PRESS POWER BUTTON TO
TURN OFF THE VCR.
VCR CLOCK IS NOT SET
CORRECTLY SET VCR CLOCK.
RECORDING MODE
CANNOT BE ENGAGED. THE ERASE PREVENTION
TAB ON THE CASSETTE IS
MISSING. PLACE A PLASTIC TAPE
OVER THE HOLE.
NO PICTURE OR POOR
PICTURE ON PLAYB
ACK
MODE .
THE TV AND OR VCR IS IN THE TV
MODE .
SET YOUR TV TO THE VCR MODE
ANDO RO PRESS VCR / TV
BUTTON ON THE REMOTE
CONTROL SO THAT VCR
APPEARS ON THE DISPLAY .
THE TV FINE TUNING IS NOT SET
CORRECTLY ..
FINE TUNE YOUR TV
NOISE IN PICTURE ON
PLAYBACK .
VIDEO HEADS ARE DIRTY . HEAD CLEANING IS NECESSARY
CONSULT THE NEAREST HITACHI
AUTHORIZED SERVICE CENTER .`
PLAYBACK PICTURE IS NOISY . THE TRACKING CONTROL IS NOT
SET .
ADJUST TRACKING CONTROL
CORRECTLY FOR A BETTER
PICTURE .