HP S7300CL User Manual
Page 8
4
Upgrading and Servicing Guide
disconnecting the hard disk drive cables
4 Release the drive from the chassis by following the
method appropriate for your PC model.
•
To release a drive from the chassis of the S0000
series, lift the release tab (1) on the latch drive
bracket of the drive you want to remove, and
then slide the drive from its drive bay (2). (The
latch drive bracket secures the drives in their
respective positions in the chassis.)
removing a drive from the S0000 series
•
To release an optical drive or diskette drive from
the chassis of the 8000 series, slide the drive
lock mechanism (1) to unlock the drive in the
drive bay and pull the drive out of the drive
bay (2).
removing an optical or diskette drive from
the 8000 series
•
To release a hard disk drive from the chassis of
the 8000 series, slide the drive lock mechanism
(1) to unlock the drive in the drive bay, remove
the metal drive shield (2) by pressing and lifting
the two tabs on one side of the shield, and then
pull the drive out of the drive bay (3).
3
1
4
2
removing a hard disk drive from the 8000
series
5 For both the S0000 and 8000 series, if you are
replacing the old drive with a new drive, remove
the four screws (4) (two on each side) from the
old drive. You need these screws to install the new
drive.