Hoover lV - Manual (Page 11)

To connect and
remove tools
To connect the tools, insert end
of tool into the extension wand
and snap into position. To
disconnect, press down on the
center of the white plastic spring
latch to release.
Tools may also be attached to
the hose grip by revolving the
plastic latch ring to accept the
button projection on the tool.
Then, turn the latch ring as
shown to lock the tool in place.
To remove the tool, reverse the
above procedure.
The power cord leading from the
hose connection to the receptacle
on the cleaner base need not be
connected when using the
cleaning tools.
However, to
avoid damage to the cord,
leave cord connected to the
receptacle on the cleaner.
To clean hard to
reach areas
Use the curved wand with the
extension wand. The tools at-
tached to the curved wand will
enable you to clean many hard
to reach areas; especially crown
moldings, tops of drapery rods,
shelves, and picture frames.
10