Harbor Freight Tools GREYHOUND 65761 - Manual (Page 15)

SKU 65761 For technical questions, please call 1-800-444-3353. Page 15
tecHnicaL
speciFications
Engine Type
9 HP, Air Cooled, Single
Cylinder, 4 Stroke
Overhead Valve
Engine Family 8CGPS.2702GC.
Displacement 270cc
Rotation
viewed from PTO
(power takeoff - the output shaft)
Counterclockwise
Fuel
Type
89+ octane unleaded
gasoline
Capacity 1.2 Gallons
Engine Oil
Type
10W30 (above 32° F)
5W30 (at 32° F or
below)
Capacity 1.1 Quarts
Spark Plug
Type F7RTC
Gap 0.028 - 0.031”
Valve
Clearance
Intake .005” - .007”
Exhaust .007” - .009”
Speed
Idle 1,600 RPM
Maximum 2,600 RPM
servicing
to prevent
serious injurY
FroM accidentaL
starting:
turn the power switch of the
equipment to its “oFF”
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
performing any inspection,
maintenance, or cleaning
procedures.
to prevent
serious injurY
FroM equipMent FaiLure:
do not use damaged
equipment. if abnormal noise,
vibration, or excess smoking
occurs, have the problem
corrected before further use.
Maintenance procedures
Many maintenance procedures,
including those not detailed
in this manual, will need to
be performed by a qualified
technician for safety. if you
have any doubts about your
ability to safely service the
equipment or engine, have a
qualified technician service the
equipment instead.
note: Warranty is void if proper mainte-
nance and servicing procedures are
not followed.
engine oil change
caution! Oil is very hot during opera-
tion and can cause burns. Wait for
engine to cool before changing oil.
Place a drain pan (not included) un-
1.
derneath the crankcase’s drain plug.
Remove the drain plug and, if pos-
2.
sible, tilt the crankcase slightly to help
drain the oil out. Recycle used oil.
Replace the drain plug (and gasket, if
3.
supplied) and tighten it.
Refill the oil to the proper level follow-
4.
ing the instructions under the Starting
the Engine section.