Harbor Freight Tools GREYHOUND 65761 - Manual (Page 13)

SKU 65761 For technical questions, please call 1-800-444-3353. Page 13
A close-up of this Push Pin (26) is
shown in FIGURE 3 on page 5. Tilt
the unit to the vertical position as
shown in FIGURE 4, and replace
both the Push Pin (26) and the Hair
Pin Clip (29) into the vertical posi tion
hole (See FIGURE 1). Reverse the
process to return to the horizontal
position.
Figure 4
Vertical Position
Place
Log
Here
Base
Start the Engine, following the steps 3.
listed in the “start procedure” sec-
tion of this manual.
Place a log, no more than 25” long
4.
and 8” diameter, on the splitter base.
note: Maximum diameter of the wood that
can be split may vary depending on
the density of the wood.
Move the Directional Valve (58) into
5.
the lower position; moving the Slide
Assembly (3) to split the log.
To stop the advance of the Slide As-
6.
sembly at any time, move the Direc-
tional Valve to the middle position.
Once the log is split, move the Direc-
7.
tional Valve to its upper position to
back the wedge off the log and re-
move the split pieces.
Continue as detailed above until all
8.
logs are split.
To prevent accidents, turn off the
9.
engine and disconnect its spark plug
wire after use. Wait for the engine to
cool, clean external parts with clean
cloth, then store the equipment out
of children’s reach according to the
Storage instructions in this manual.
transporting the Log splitter
Warning!
iMportant inForMation
This trailer’s Hitch Coupler MUST
be properly secured to the hitch ball of
the towing vehicle. After assembly and
attachment, pull up and down on the Hitch
Coupler to make sure the hitch ball is fitting
snugly in the Hitch Coupler. there must
be no play between the hitch ball and
Hitch coupler. If there is play, tighten the
Adjustment Nut until no play is present. If
the Adjustment Nut is too tight, the Handle
will not lock. carefully read and follow
the complete instructions in this manual
BeFore setup or use.
if the coupler is not secured properly,
the ball could come loose while the trailer
is in motion, possibly causing property
damage, serious personaL injurY,
or deatH.
note: This Log Splitter is not road legal
and should not be conveyed on pub-
lic roads.
When transporting the Log Splitter, •
make sure your hitch (not included)
is compatible with the Hitch Coupler
(9).
Follow all of the safety warn ings for
•
towing in the vehicle’s manual.