HP DV6 - Manual (Page 90)

11. Remove the three Phillips PM2.5×5.5 screws (1) that secure the system board to
the base enclosure.
Reverse this procedure to install the system board.
Fan/heat sink assembly
NOTE: The fan/heat sink assembly spare part kit include replacement thermal material. Replacement
thermal material is also available in the Thermal Material Kit, spare part numbers 685348-001 (for use
on computer models equipped with an AMD processor) and 682100-001 (for use on computer models
equipped with an Intel processor).
Description Spare part number
For use only on computer models equipped with an AMD processor and a graphics subsystem
with discrete memory 682179-001
For use only on computer models equipped with an AMD processor and a graphics subsystem
with UMA memory 682178-001
For use only on computer models equipped with an Intel processor and a graphics subsystem with
discrete memory 682061-001
For use only on computer models equipped with an Intel processor and a graphics subsystem with
UMA memory 682060-001
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side of
the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature
sensor and is designed to turn on automatically when high temperature conditions exist. These
conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
82 Chapter 4 Removal and replacement procedures