Hobart Welding Products HANDLER 140 OM-925 - Manual (Page 24)

.
A complete Parts List is available at www.HobartWelders.com
OM-925 Page 20
5-9. Threading Welding Wire
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Gun Conduit Cable
Lay gun cable out straight.
Tools Needed:
Pull and hold wire; cut off end.
Open pressure assembly. Make sure
feed roll is set to correct groove to
match wire size (see Section 7-4).
.
Hold wire tightly to keep it from unraveling.
6 in
(150 mm)
6
1 3
4
5 2
1
2
4 in
(102 mm)
Straighten approximately 3 or 4 inches (76 or 102 mm) of wire before inserting
wire into guides. Push wire thru guides into gun; continue to hold wire.
3