Horizon Fitness T64 - Manual (Page 8)

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
7
DO NOT CUT STRAPS UNTIL STEP 1.4!* Disassemble box and remove the DO NOT CUT STRAPS UNTIL STEP 1.4!* DO NOT CUT STRAPS UNTIL STEP 1.4!*
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Reach under treadmill running deck to locate parts box.
Remove plastic wrap from console masts.
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
Lift LEFT CONSOLE MAST into LEFT CONSOLE MAST LEFT CONSOLE MAST
upright position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it’s own.
Move LEFT SIDE LINKAGE ARM
into position. Insert TEFLON TT
WASHER (B) (2 pcs) and WASHER (B) WASHER (B) BOLT
(A) and tighten. (A) (A)
Repeat on the right side.
Now cut the banding straps and
remove remaining packaging
material.*
Lift the RUNNING DECK until RUNNING DECK RUNNING DECK
lock latch is fully engaged.
Remove CONSOLE from box CONSOLE CONSOLE
and place out of the way.
Lower the treadmill RUNNING Lower the treadmill Lower the treadmill
DECK from the folded position DECK DECK
by stepping on LOCK LATCH on
lower right side.
ASSEMBLY STEP 1
ASSEMBLY STEP 2
A
B
C
D
A
B
C
PRE-ASSEMBLY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
* NOTE: If the straps have been removed before completing
STEP 1, refer to the TROUBLESHOOTING section (page 26) TROUBLESHOOTING TROUBLESHOOTING
in order to restore the treadmill to its proper position.
LEFT CONSOLE MAST
LEFT SIDE LINKAGE ARM
BOLT A
1
3
2
WARNING